Installation & Documentation

DESIGN QUALIFICATION

Defines the functional and operational requirement and specification of the equipment and details the conscious decisions in the selection of the supplier.

INSTALLATION QUALIFICATION

Confirms that all the equipment was installed to specifications. All of the model and serial numbers are documented.

OPERATIONAL QUALIFICATION

Verification of operator control feature, safety features, software feature, Stan by feature with alarms action.

PERFORMANCE QUALIFICATION

Confirms that the equipment working within operating range at stipulated product load.

PRE INSTALLATION REQUIREMENT

Surrounding	Area	Clean & free from dust
	Temp	20 ℃ ~ 35 ℃ (Recommended using AC)
	Level	Horizontally leveled
Clearance Space	Right & left Side	Minimum 500mm
	Back Side	Minimum 500mm
	Top Side	Minimum 500mm
	Door Open Area	Greater than doors width size of equipment
Refrigeration unit (for Walk in type chamber)	Distance between equipment and compressor unit should not exceed 45 feet
	3“ diameter hole required at wall for passing copper pipe of split type refrigeration unit.
	Proper shade is required to protect compressor unit from rain water.
Required stabilized power supply for equipment	For non walk-in type	Single phase, 230+10 VAC, 50 Hz, 20 Amp with proper earthing
Required stabilized power supply for equipment	For walk-in type	Three phase, 440+10 VAC, 50 Hz, 32 Amp with proper earthing
Required UPS for PLC & Control system	Single phase, 230+10 VAC, 50 Hz, 250 VA
Required LAN port [I/O] for communication of equipment and software	Information outlet [I/O] for each equipment and distance between equipment & port should not exceed 2.5 meters.
Drainage	Level	Concealed (below ground level)
Continuous water supply (For Temperature & Humidity base Equipment)	Pipe specification	3“ diameter PVC
	Water quality	Dust free Demineralized or soft water
	Pressure	1 kg/cm ~ 1 Bar ~ 15 psi approx
	Valve diameter	½ “BSP